A decision to do prototyping and short (very) run jobs in-house ia causing
me to get back into hardware after about 20 yrs. Hence, the need for advice.
I will likely have to buy or build everything needed, so I thought a tool
that could be used on PTH & SMT rework might be a good thing.
>
> > new mortgage
>
> Hm. Maybe not. You can do it in a SMD reworking station by heating the
> whole board and extracting the chips when the solder melts
> (you want the
> top heat on low and the bottom way up high). You will probably need to
> adjust the jigs to make the board fit etc. Of course I assume
> you have a
> SMT reworking station ...
>
> Peter
>
>

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads