I'm doing a little project using an f876 storing and retrieving data (a lookup
table) into the EEDATA memory. The routine works fine, except for receiving data
from the PC. I send the data using VB6 MSComm1 but I get an overrun error after
about 4 bytes. even if I change the speed from 19200 down to 9600, exactly the same
thing happens. I have not got any hardware handshaking, so I am assuming that I
will have to handshake by sending back an acknowledgement byte before sending the
next byte down to the PIC. Am I missing something or is this the right way? Thanks.



********************************************************************
This email and any attachments are confidential to the intended
recipient and may also be privileged. If you are not the intended
recipient please delete it from your system and notify the sender.
You should not copy it or use it for any purpose nor disclose or
distribute its contents to any other person.
********************************************************************

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu