Having searched the archives without success, can anyone suggest a good
way to do vias on smt double sided boards in low volume production ....

Most of my stuff is single sided hand soldered, but I have a short run
of two sided with half a dozen vias needed on each densely packed board

For prototypes I just use scrap from led legs otherwise discarded, and
soldered both sides, but something faster is needed with a few hundred
vias to do.

Stuart Meier

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body