At 01:54 PM 2/13/02 -0600, you wrote:
>Anybody out there got a way to translate AutoCad 14 to IGES?  I have a
>mechanical drawing of a circuit board that I ported to AutoCad from Eagle.
>So far so good, but I need to read that drawing with another CAD system that
>doesn't speak AutoCad, but does speak IGES.  IGES used to be an opotion in
>AutoCad 13, but was removed in 14.

Can you use DXF instead?

Best regards,

Spehro Pefhany --"it's the network..."            "The Journey is the reward"
speff@interlog.com             Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog  Info for designers:  http://www.speff.com
9/11 United we Stand

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.