I have no ideea were was stuck this message so I'll post again,
please take a look and tell me your ideeas about what is wrong here...
>
> Sorry for bothering you, but I'm feeling so annoyed !
> I don't understood from pic archive examples and data sheet if
> master clock is generated automaticaly by the MSSP module or not.
> My first thought was yes. I understood that 8 bites of data can be
> transmitted synchronously with clock pulses.
> I'm trying to initiate a communication using master1 mode, the
> sspstat = 0b_0000_0000 and sspcon = 0b_0010_0010 are set appropiate
> for fosc/64. The pins used are rc3 ( spi-clk ) and rc4 ( spi-data in )
> and an extra pin for chip select, all direction are set correct in
> TRIS register.
>
> According to data sheet:
> " In master mode the data is transmitted/received as soon as the
> SSPBUF register is written to " and:
> "The master can initiate the data transfer at any time because it
> controls the SCK "
>
> My device ( MAX121 ) is connected to receive clocks from PIC and to
> deliver data's as soon as the chip select ( or convst ) is tied to gnd.
> But how can be determined MSSP to send clocks ? The only way I saw is
sending dummy data, but then how can be readed incoming datas ?
( I don't want to use slave mode ).
  And I don't saw any damn clock on to my scope...
>
> Thank you in advance,
> Vasile
>
>

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads