I'm having trouble ICSP programming my 16LF627's.  The 16F627's program
fine.  My circuit has a 10K pullup on MLCR, and RB6 and RB7 are not attached
to anything.  There is less than a 10mA load on Vcc.

Here's my processor configuration:

        __CONFIG _PWRTE_ON & _WDT_OFF & _LVP_OFF & _INTRC_OSC_NOCLKOUT & _MCLRE_ON
& _CP_OFF & _BODEN_ON

My Promate II is using the ICSP module as I said the same circuit w/ the
16F627 programs fine.

Promate II settings:
device = 16F627 (there's no LF option)
vdd min = 3.0V
Vdd max = 5.5V
Vpp = 13.0V
no sqtp
low voltage program not enabled

Any suggestions?

Thanks,

Tim Crist

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body