Hi fellows, I'm living in hell since I started to write a D/A interrupt
driven subroutine. Does anybody has any tip I don't have?

CMCON = 5    : using only 1 comparator

Things I observed:

1) if I disable comparators interrupt enable flag (CMIE) inside the
interrupt routine, and enable it again later in the main program i do not
get any further interrupt (duh?) (I have a bit being forced to one at the
entry and to 0  at the int sub routine exit). In the other hand I have T0
interrupt running absolutelly flawlessly refreshing my display

2) Probabily the comparators have no histeresis because I can observe until
1 to 8 pulses in my spy bit( see above), it's not a problem because I'm
concerned about the first one so I can disregard the others.

    I'm relatively confident I'm taking care of  GIE, CMIE and CMIF bits, I
have to deliver this software tomorrow morning but I'm almost giving up does
anybody have any advise????

Thanks in advance
Horta

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads