I will be making an adapter that will connect between the PicStart Plus
Development Programmer and my development board I am currently designing.

I am using a 4-Pin 20 MHz chip oscillator (SG-615P) with an Enable pin which
I can tie to gnd to disable the CLK.

I currently don't use the LVP mode.

Doesn't Microchip have an App note for ICSP?  I could not find anything on
their site.

Tim

-----Original Message-----
From: Jay Hanson [mailto:jay@CHATZILLA.COM]
Sent: Tuesday, January 22, 2002 11:24 AM
To: PICLIST@MITVMA.MIT.EDU
Subject: Re: [PIC]: In-Circuit programming for 16F877


> Does anybody know how to program a 16F877 while In-Circuit or know of an
> example or Application note.

You should first decide if you want to use LVP (low voltage programming).  I
built a board where a 16F628 programs a 16f876.  With LVP I don't have to
generate 13v.

Jay

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads