maybe you need to read something, it's easy and written like a story:
http://www.myke.com/pdfs/0071341862_ch23.pdf
then to see this code:
http://www.geocities.com/vsurducan/electro/PIC/jseriala.txt
and after that to connect two f84 usig that serial code without any
level adapters.
regards, Vasile

On Mon, 21 Jan 2002, Keith Christopher wrote:

> Actually I'm using a 16F84A 10mhz. I am using pic
> basic. I had asm code but man picbasic is short and
> sweet.
>
>
>
>
>
> --- David Duffy <piclist@AUDIOVISUALDEVICES.COM.AU>
> wrote:
> > Keith wrote:
> > >I'm seeing (direct rb3) to RX on 232 lvl, I get the
> > >message but once the message is sent no other i/o
> > to
> > >RX pin, put the meter on it voltages were in the mV
> > >range.
> > >
> > >Weird, like the pic after sending the msg is acting
> > >like a pull down.
> >
> > Do you have the RS232 levels going into the PIC
> > directly?
> > I hope not. Maybe I misunderstood?
> > Hang on... why are you using RB3 for serial comms?
> > You could just use the on-board UART couldn't you?
> > Do you have LV programming enabled & are using RB4?
> > Is this assembler code or a basic stamp type of
> > thing?
> > Regards...
> >
> > --
> > http://www.piclist.com hint: PICList Posts must
> > start with ONE topic:
> > [PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other
> > [BUY]:,[AD]: ->Ads
> >
> >
>
>
> __________________________________________________
> Do You Yahoo!?
> Send FREE video emails in Yahoo! Mail!
> http://promo.yahoo.com/videomail/
>
> --
> http://www.piclist.com hint: PICList Posts must start with ONE topic:
> [PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads
>
>

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads