At 03:34 PM 18/01/2002 +1100, you wrote:
>Hi Guys,
>
>Once again, thank you for all the replies. I decided to put the blip in the
>"too hard" basket for the time being and continued on finishing this project
>off. I had been testing that the software was correct using my JW parts -
>without being too concerned about timing.
>
>I just burnt a plastic part in order to check all my timings and discovered
>no blip at all! It's only happening on the JW parts. Not the first time I
>have noticed differences between the JW and plastic parts.

Try covering the JW's window with black tape. You can get some odd
things happening due to stray light shining on it while operating.
Regards...

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads