Hi Guys,

Once again, thank you for all the replies. I decided to put the blip in the
"too hard" basket for the time being and continued on finishing this project
off. I had been testing that the software was correct using my JW parts -
without being too concerned about timing.

I just burnt a plastic part in order to check all my timings and discovered
no blip at all! It's only happening on the JW parts. Not the first time I
have noticed differences between the JW and plastic parts.

Just thought I might share this with the list.

Regards,

Sean

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads