>
>Before doing that however, I just wanted to ask if I was doing anything
>wrong? The state of the port(s) on power-up is not known right?

It SHOULD be an input, and not driving at all.

>  But they
>seem (from my limited experience) more likely to be low than high. Can I get
>the pin driven high any sooner or would I have better results by simply
>inverting the logic for the LED and driving the Pin High when I want the LED
>on?


Put a pull-down resistor out there, and see what happens.

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads