This may seem like a stupid question but why does my PIC reset from noise on
Vcc?

The noise is generated by the flip of a switch that connects or disconnects
Vcc to a 74VHC125, NC7S14, & 93C86.
I have .1uf caps across the power supply at each chip including the PIC.

The MCLR is tied to Vcc with a 1K ohm resistor.

I don't have a oscope handy to look at the Vcc line right now.

Am I missing something...

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body