Also check out Microkinetics at www.microkinetics.com.  I got some of my
parts there after doing a lot of research.

David P. Harris wrote:

>Yeah, check them out at: http://www.flashcutcnc.com/html/machines.html
>The Sherline 5400 complete: $2695
>David
>
>Chris Eddy wrote:
>
>>It was about $4k all told, and it can fit about 6" by 9" by 2" (piece
>>must fit under the end of the Z axis beam). It sticks on the X axis on
>>the far right side for the last inch, so I can do about 6x8 until I get
>>off my ass and fix the sticking spot.
>>
>>FlashCut actually sells completed systems.
>>
>>I typically take some MDF board and fit it to the work surface, and then
>>mill a groove or recession to hold the piece.
>>
>>Chris~
>>
>>Sean Alcorn - Avion Sydney wrote:
>>
>>>on 9/1/02 12:03 PM, Chris Eddy at ceddy@NB.NET wrote:
>>>
>>>Chris,
>>>
>>>>I have a Shurline mill that I converted with steppers and a piece of
>>>>purchased software (flashcut) that I cut this sort of stuff on. It is a
>>>>big learning curve, and not cheap, but worth the effort in the end. I
>>>>cut lots of stuff, from enclosures to mounting pieces to one of test
>>>>jigs.
>>>>
>>>Sounds like a neat machine. How much did it cost you all up and how large
>>>jobs can you do?
>>>
>>>Regards,
>>>
>>>Sean
>>>
>>>--
>>>http://www.piclist.com hint: The list server can filter out subtopics
>>>(like ads or off topics) for you. See http://www.piclist.com/#topics
>>>
>>--
>>http://www.piclist.com hint: The list server can filter out subtopics
>>(like ads or off topics) for you. See http://www.piclist.com/#topics
>>
>
>--
>http://www.piclist.com hint: The list server can filter out subtopics
>(like ads or off topics) for you. See http://www.piclist.com/#topics
>
>
>

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics