How about letting the WDT time out... That to all intents and purposes is an MCLR -----Original Message----- From: pic microcontroller discussion list [mailto:PICLIST@MITVMA.MIT.EDU]On Behalf Of Vitaliy Maksimov Sent: Friday, 21 December 2001 19:27 To: PICLIST@MITVMA.MIT.EDU Subject: Re: [PIC]: Implementing MCLR in software Steve, Thank you for your input. I had the same idea (using an I/O pin to pull the MCLR LOW), but I've seen a 12C508 that does [apparently] the same thing in software, without any external hardware. When you send an "ATZ" command to the chip, it displays a welcome message (like it was just turned on), and all of the registers are reset. I just want the circuit to be less cluttered.. Vitaliy ----- Original Message ----- From: Steve Faulkner To: Sent: 12.20.2001 11:15 PM Subject: Re: [PIC]: Implementing MCLR in software > I know of a board with this type of ability. It was done by external > circuitry connected to the hardware reset line and an I/O pin. When the I/O > pin pulsed the external logic was triggered to hold the CPU in reset for a > certain amount of time (lengthening the pulse sent by the I/O line). Of > course this requires that the CPU I/O line does re-trigger a reset due to a > reset. Should be ok if the I/O defaults to an input or tri-state and pull-up > is put on the line. On the board I'm thinking of the external logic was a > PLD, but it would seem to me that a flip-flop and an RC network would due > the trick of creating a pulse-stretcher if you've got the right electronics > know-how (not something I could come up with without some deep thinking). > > ----- Original Message ----- > From: "Vitaliy Maksimov" > To: > Sent: Thursday, December 20, 2001 8:41 PM > Subject: [PIC]: Implementing MCLR in software > > > > Hello everyone, > > > > I'm trying to find out if there's a way to reset a 16F73 without using > > external circuitry (basically doing a RESET in software). I need the chip > > to act as if the MCLR pin was pulled LOW, when it receives the "ATZ" > > command. Can this be done without utilizing the Watchdog Timer? > > > > Any suggestions will be greatly appreciated! > > > > Vitaliy > > > > -- > > http://www.piclist.com hint: The PICList is archived three different > > ways. See http://www.piclist.com/#archives for details. > > > > > > > > -- > http://www.piclist.com#nomail Going offline? Don't AutoReply us! > email listserv@mitvma.mit.edu with SET PICList DIGEST in the body > > > -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body -- http://www.piclist.com hint: To leave the PICList mailto:piclist-unsubscribe-request@mitvma.mit.edu