Sorry if I was not so clear on that.
I have a ATE that has lots of devices attached to it and they are all
controlled through GPIB. Now I need one more device (digital I/O). So I
thought may be easier if I build the
device myself rather than buying the expensive one off the shelf. So I am
trying to add my new device to the system. PIC is the micro to control the
digital I/O and I need to make it to communicate through the GPIB.

I hope this clears things up a bit.




                    "WEBB,TIM
                    (A-Sonoma,ex1)        To:     PICLIST@MITVMA.MIT.EDU
                    "                     cc:
                    <tim_webb@AGIL        Subject:     Re: [PIC]:HELP WITH GPIB
                    ENT.COM>
                    Sent by: pic
                    microcontrolle
                    r discussion
                    list
                    <PICLIST@MITVM
                    A.MIT.EDU>


                    21/12/01 12:16
                    Please respond
                    to pic
                    microcontrolle
                    r discussion
                    list






Are you using the PIC as a GPIB Bus or is the GPIB bus on your computer?

If the GPIB Bus is on the computer are you referring to your 25-Pin
Parallel/Printer Port?

Are you trying to use the PIC to interface between a GPIB Bus on a computer
and some other device?



-----Original Message-----
From: Shirollah Ghadirian
[mailto:Shirollah.Ghadirian@ENERGY.INVENSYS.COM]
Sent: Thursday, December 20, 2001 3:01 PM
To: PICLIST@MITVMA.MIT.EDU
Subject: Re: [PIC]:HELP WITH GPIB


Sorry guys,
Yes I am trying to use a PIC to run the GPIB bus to control some digital
I/O.




                    Bob Barr
                    <bbarr@CALIFOR        To:     PICLIST@MITVMA.MIT.EDU
                    NIA.COM>              cc:
                    Sent by: pic          Subject:     Re: [PIC]:HELP WITH
GPIB
                    microcontrolle
                    r discussion
                    list
                    <PICLIST@MITVM
                    A.MIT.EDU>


                    21/12/01 11:40
                    Please respond
                    to pic
                    microcontrolle
                    r discussion
                    list






On Fri, 21 Dec 2001 11:21:41 +1300, Shirollah Ghadirian wrote:

>HI every one,
>I am trying to use GPIB in my system and have no idea where to start or
>even if some one already done it.
>
>Can any body help me please.

Could you be a bit more specific as to just what sort of help you
need?

Are you planning to use a PIC to run the GPIB bus to control some
external test equipment?

Are you planning to use a PC to communicate with a PIC-based device
over the GPIB bus?


Regards, Bob

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.