----- Original Message -----
From: "David VanHorn" <dvanhorn@CEDAR.NET>


> I'm looking for a chopped bridge driver, preferrably a dual, for use with
> low voltage (6V-8.5v) motor supplies.
>
> Everything I've found so far wants at least 10V, but I don't have 10V to
give!

Try Allegro micro systems, they have a few bridge drivers, that run from VCC
to 45+V

Two the come to mind are the A3952SB (single driver) and the A3964SB (dual
driver)

Regards,

Kat.


____________________________________________________________________________
 /"\   ASCII Ribbon Campaign  |        K.A.Q. Electronics
 \ / - NO HTML/RTF in e-mail | Software and Electronic Engineering
 X  - NO Word docs in e-mail  |      Perth Western Australia
 / \                                            |        Ph +61 419 923 731
____________________________________________________________________________

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.