Ooops, I misunderstood. But possibly the same reasoning applies. If the 12-bit configuration word were to be stored at 0xFFF in a hex file the lower 8 bits would end up at 0x1000 or 0x000. I'm not sure about the mapping from addresses in HEX files to addresses in the PIC, though. /\/\/\/*=Martin ----- Original Message ----- From: "Mark Skeels" To: Sent: Tuesday, December 11, 2001 12:31 PM Subject: Re: [PIC]:programming a 12c509A; configuration word > I think you must be referring to the OSCAL value. I understand this is moved > into the register within the firmware program. > > I am talking about the configuration word which configures the code protect, > oscillator mode, watchdog timer, etc. > > Mark > > > ----- Original Message ----- > From: "Martin Peach" > To: > Sent: Tuesday, December 11, 2001 11:21 AM > Subject: Re: [PIC]:programming a 12c509A; configuration word > > > > Probably because the calibration value is encoded as a MOVLW XX > instruction > > at the address 0x3FF (I have one here that has 0xC50 there, so my > > calibration value is 0x50 and the opcode for MOVLW is the 0xC in the 4 > high > > bits.) Since the instructions are all 12 bits wide and a HEX file deals > with > > 8-bit values, the instruction is spread over two bytes in the HEX file. > > > > /\/\/\/*=Martin > > > > ----- Original Message ----- > > From: "Mark Skeels" > > To: > > Sent: Tuesday, December 11, 2001 10:30 AM > > Subject: [PIC]:programming a 12c509A; configuration word > > > > > > > Hi, List. > > > > > > I am building a test fixture for a product we make using a 12C509A. One > of > > > it's functions is integral programming of the PIC using ISP. > > > > > > I have got to the point where I am parsing the HEX file generated by > MPASM > > > and was suprised to find that the configuration word information appears > > in > > > the second-to-last line in the HEX file, but at address 0xFFE, _not_ > 0xFFF > > > as I expected. > > > > > > What am I missing, or can someone explain this to me? The ISP app note > for > > > the 12C5XX from MChip clearly states that the config word is stored at > > > location 0xFFF. > > > > > > Mark Skeels > > > Engineer > > > Competition Electronics > > > meskeels@earthlink.net > > > > > > Soli Deo Gloria! > > > > > > -- > > > http://www.piclist.com#nomail Going offline? Don't AutoReply us! > > > email listserv@mitvma.mit.edu with SET PICList DIGEST in the body > > > > > > > > > > -- > > http://www.piclist.com#nomail Going offline? Don't AutoReply us! > > email listserv@mitvma.mit.edu with SET PICList DIGEST in the body > > > > > > -- > http://www.piclist.com#nomail Going offline? Don't AutoReply us! > email listserv@mitvma.mit.edu with SET PICList DIGEST in the body > > -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body