Hi, I have an IR xmitter sending the string "1234567890abcxyz" over my
setup. (F628 - PWM 40khz carrier, RB2 TX 1200 baud).
The receiver is a F84 hooked to an LCD with the RX hooked directly to a
GP1U26x module.
The strange part is I have the two units 3 feet apart on my bench, when
xmitting on a straight line of sight, I get about 60% errors in the string.

However, when I place my hand directly in front of my two diode emitters,
I get 100% accuracy everytime ? Could somebody explain this or possibly
a solution ?
Thanks,
Kevin

 Xmit Circuit was figure 6 from
http://www.rentron.com/Infrared_Communication.htm

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body