>Hrmm.  Those look OK.  I've done the same thing except for the baud rate.
>Do you have a schematic you can post somewhere, even if just the comms
>part?  Maybe there's a clue there.
>
>Dale
The xmitter circuit is on
http://www.rentron.com/Infrared_Communication.htm  figure 6.
I do not think this is the problem.
The rx circuit is an lcd hooked to a F84, I have used this plenty of times
It works fine connected to my serial port on the PC.
The only change I made was to disconnect the TX line and connect the
IR unit (GP1U26X). Pin1 to the RX pin on the F84, pin2 to Vcc and
pin3 to GND.  When I make this change, the bottom line of the LCD starts
flashing garbage, whether I am sending the IR ddata or not.
My code only writes to the bottom line.
When I disconnect the IR module and put  the TX line from the PC the LCD
display clears and displays any character I send properly.
Any thoughts ?
Thanks,
Kevin

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body