or if you want to do IrDA communication, check out MCP2150 or MCP2120 from Microchip, which takes care of the protocol stacks.
regards,
Donny Tan
>From: Robert McAtee
>Reply-To: pic microcontroller discussion list
>To: PICLIST@MITVMA.MIT.EDU
>Subject: Re: [PIC]: Wireless
>Date: Mon, 5 Nov 2001 15:00:27 -0600
>
>Salah, if you can use Infa-Red, and only need "on"-"off" you might look at
>the Fire-Stick at http://www.rentron the transmitter/receiver kit I built
>in about an hour will give you 4 line output for a combo of 16, 15 active
>BCD outputs. With a cheap bcd to 16 line decoder you can see a lot of
>combinations of off/on. I can transmitt the 38KC signal close to 100 feet
>dependabaly in broad daylight. ==Mac== Amateur Radio AG5F, Abilene, TX.
>
> >----- Original Message -----
> >From: "Salah M."
> >To:
> >Sent: Sunday, November 04, 2001 11:26 PM
> >Subject: [PIC]: Wireless
> >
> >
> >> Hello List,
> >> I`d like to start a new project concerning remot-controlling ... any
> >> information about wireless projects based on PIC MCU please...... is it
> >> possible to control the BlueTooth module via the PIC ? most of the
> >resources
> >> that I got is talking about BT with AVR or ARM from Atmel but I am
> >wondering
> >> if I can do it with PIC .
> >>
> >> Regards
> >> Salah.
> >>
> >> Hugle-Electronics,Inc.
> >> Tokyo/Japan.
>
>--
>http://www.piclist.com hint: The PICList is archived three different
>ways. See http://www.piclist.com/#archives for details.
>
>