Does anyone know how to get "request" the CAN "controller Area Network" ID
from a device using software. I have a CAN bus transducer and have the
paperwork for the protocol but no ID. I'm using an Infineon 167CR-LM test
board to try in establishing communications with the transducer. I am new to
the "CAN" bus standard. I think I have to send a remote frame "request
information" to the transducer with the ID of the device (in this case the
transducer). I am using the same transceiver on the test board as the
transducer transceiver and can see the communication with a scope. But,
without an ID I'm stuck.

Edward S. Bockhoefer
PAT America, Inc.
Software Engineer,
Mobile Plant Electronics Division
Phone:  USA (717)263-7655
Fax:    USA (717)263-7845
mailto:e.bockhoefer@patamerica.com

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu