Hello Allen,

At 12:54 PM 10/16/01 -0700, you wrote:

   weekend, I can't get the programmer to work.  The
>programmers "POWER" and "ACTIVE" indicators are lit,
>but the software keeps telling me that no hardware is
>connected.  The port (parallel) is fine, because I
>just disconnected my printer to try out the programmer
>(and confirmed that the printer still works on the
>port when I remove the programmer).

I haven't used the PicLite, but suggest you check the printer type in
your computer's BIOS/CMOS settings.  If it's set to "standard", you
get fewer status signals back from the printer. Try setting it to "ECP"
or "EPP" mode.

Good luck,

Neal Robles


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com


--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.