How are you connecting to the PC? What programmer are you using? Are you using the ICD? Are you writing ASM code or using a compiler? All of these (plus others, I imagine) could affect your results. ----- Original Message ----- From: "Keong" To: Sent: Saturday, October 13, 2001 2:30 PM Subject: Re: [PIC]:RB6 & RB7 > I am implementing the micro-controller in breadboard > and it is a 16F873 > > > --- Ned Konz wrote: > > On Saturday 13 October 2001 12:56 pm, Keong wrote: > > > Hi > > > > > > I am new to PIC and I need someone to clear my > > doubt. > > > When I output a 1 to all the pins, the LED > > connected > > > to it will lit up except for pin RB6 and RB7. Is > > there > > > another config bit to set before I can lit LED > > from > > > RB6 and RB7? > > > > If you're using MPLAB-ICD, it uses RB6 and RB7 to > > communicate with the ICD > > pod, and so you can't use those pins while using the > > ICD. > > > > -- > > Ned Konz > > currently: Stanwood, WA > > email: ned@bike-nomad.com > > homepage: http://bike-nomad.com > > > > -- > > http://www.piclist.com hint: To leave the PICList > > mailto:piclist-unsubscribe-request@mitvma.mit.edu > > > > > > > __________________________________________________ > Do You Yahoo!? > Make a great connection at Yahoo! Personals. > http://personals.yahoo.com > > -- > http://www.piclist.com hint: To leave the PICList > mailto:piclist-unsubscribe-request@mitvma.mit.edu > > -- http://www.piclist.com hint: PICList Posts must start with ONE topic: [PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads