On Saturday 13 October 2001 12:56 pm, Keong wrote:
> Hi
>
> I am new to PIC and I need someone to clear my doubt.
> When I output a 1 to all the pins, the LED connected
> to it will lit up except for pin RB6 and RB7. Is there
> another config bit to set before I can lit LED from
> RB6 and RB7?

If you're using MPLAB-ICD, it uses RB6 and RB7 to communicate with the ICD
pod, and so you can't use those pins while using the ICD.

--
Ned Konz
currently: Stanwood, WA
email:     ned@bike-nomad.com
homepage:  http://bike-nomad.com

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu