Try this company:

      Nyco Transformer Company (PA) (610) 327-4106



I had them do a 3kv 1amp transformer for a university project... cost a
couple hundred dollars though.

Not sure they are still in business though... it was quite a few years ago.

Scott F. Touchton
1550 Engineering Manager
JDS Uniphase



                    Nick Masluk
                    <MisterTIPPY@Y       To:     PICLIST@MITVMA.MIT.EDU
                    AHOO.COM>            cc:
                    Sent by: pic         Subject:     [BUY]: 650VAC Transformer
                    microcontrolle
                    r discussion
                    list
                    <PICLIST@MITVM
                    A.MIT.EDU>


                    10/02/01 03:45
                    PM
                    Please respond
                    to pic
                    microcontrolle
                    r discussion
                    list






I'm looking for a 120VAC 60Hz to 650VAC transformer, with as high an
amperage as possible up to 2.5 amps output, 150mA at the bare minimum.
This will be used in a power supply for a pulsed Nd:YAG laser.  I would
prefer a new transformer as opposed to an old one from vacuum tube
electronics.

Thanks,

--Nick

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body