They are seperate. But within 14 inches. It turns out it was PortC.5 on Master sending to PortB.5 on Slave. ----- Original Message ----- From: "Olin Lathrop" To: Sent: Thursday, August 16, 2001 2:23 PM Subject: Re: [PIC]: Pull downs ===>> > > I have two pic chips hooked together between B.5 on a 16f876 (sender) and > > B.5 on a 16f877 (receiver). I have a 2k2 resistor between the two at the > > 16f876 (sender) side. The 16f876 (sender) line is normally low and turns > to > > high to signal it is done. The 16f877 is seeing faulse signals from the > > 16f876 that the 16f876 is not sending, I think just line noise? Can I just > > use a pulldown 10k resistor on the 16f877 side? > > Are the two PICs on the same board? If so, just wire the pins together > directly. > > > ******************************************************************** > Olin Lathrop, embedded systems consultant in Littleton Massachusetts > (978) 742-9014, olin@embedinc.com, http://www.embedinc.com > > -- > http://www.piclist.com hint: The list server can filter out subtopics > (like ads or off topics) for you. See http://www.piclist.com/#topics > > > -- http://www.piclist.com hint: The list server can filter out subtopics (like ads or off topics) for you. See http://www.piclist.com/#topics