At 8:08 PM +0200 8/13/01, wouter van ooijen & floortje hanneman wrote:
>  > When I first had trouble and went poking around, I found Microchip's
>>  note about RB3 and LVP (and then read much of the voluminous
>>  discussion about it in the PICList archives :-). I assumed that was
>>  my problem, so I temporarily tied RB3 to Vss on the board though 10K,
>>  just for programming. It didn't seem to change anything.
>
>Shouldn't that be Vdd to disable LVP? In the past I programmed some F877's
>wothout problems without connecting RB3 to anything, but with F628's (RB4!)
>this worked erratic. So always tie the LVP-enable pin low while using HVP.

Vss *is* low, isn't it? Or am I missing something obvious? (a
definite possibility...)

Dave Johnson

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body