I didn't see that anywhere in the documentation. I'll try that tonight. I'm sure it'll work. -----Original Message----- From: pic microcontroller discussion list [mailto:PICLIST@MITVMA.MIT.EDU]On Behalf Of Brandon Fosdick Sent: Monday, August 13, 2001 11:13 AM To: PICLIST@MITVMA.MIT.EDU Subject: Re: [PIC] Pocket Programmer Problem (bubblesoft) Alan Brumley wrote: > > I built the pocket programmer from bubblesoft. > I can't get it to work > with the pocketpro.exe (the nice GUI) on the webpage. I have used the > pocket.exe and have calibrated, imported, programmed, read, then exported a > hex file back to the host PC and verified that the hex files were the same. > I'm sure the communication is ok with the programmer, and the programmer can > program a PIC, but the pocketpro software gives me a timeout waiting for the > programmer board. My "pocket.dat" file has the correct com port in it, (if > I change it, BOTH programs start complaining) but there's no mention of baud > or anything in that file. Obviously I'm missing something. > Can anybody help? I get the same behavior on 2K and 98. Turn on the pocket while holding down the button closest to the LCD. Then when it says "start pocketpro.exe", start pocketpro.exe. If that's what you did and it didn't work, then I'm not sure what the problem is. -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body