> I need a possibility to reset the PIC by the software (after receiving
> a special command via serial interface). The design does not use WDT
> (otherwise it would be enough to stop executing the CLRWDT commands).

This was recently discussed, where I mentioned I was causing a reset
using the watchdog.  It was suggested that such a reset was unnecessary,
and that 'goto 0' with the registers properly set up was all that was
required.  Might that work for you?

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body