I have a design that incorperates a PIC microcontroller and
a Ubicom (Scenix) SX series Microcontroller.
For the PIC, the programming interface consists or VPP, Program CLK, =
Program DAT, GND.
For the SX, the programming interface consists of the 2 OSC pins and =
GND.
For production purposes, I would like to use the standard pin-out scheme =
and header type (if a standard actually exists)
that works with most common programmers for these devices. So during =
production, I can simply interface a programmer for these devices to the =
target board without any conversion cables. Can anyone refer to some =
online documentation that spells this out. Thanks

Neil Gandler
Founder, CTO
MAI Technology Inc.
P.O. Box 64072
Sunnyvale, CA 94088-4072
Phone & Fax: 408-904-5089
e-mail: neil_gandler@getmai.com
http://www.getmai.com

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.