I have the Sony G400, so the text is still clear at this resolution (1600x1200). So it seems like I have to have both monitor at the same resolution in order to have full screen on both monitors? Any way around this problem? Thomas >From: Robert Rolf >Reply-To: pic microcontroller discussion list >To: PICLIST@MITVMA.MIT.EDU >Subject: Re: [OT] MPLAB on dual monitors? >Date: Tue, 17 Jul 2001 11:26:29 -0600 > >Thomas N wrote: > > > > Hi everyone, > > > > I have a dual monitor setup at home (15" and 19"). When I use MPLAB > > (especially when I simulate the code), I like to see all the source code > > files displayed both both monitors. How do I do it? > > > > When I drag MPLAB over to the secondary monitor (15"), it displays full > > screen on a 15" monitor, but only haft screen on the 19" monitor. I >think > > this is because my 15" monitor resolution is set at 800x600 whereas my >19" > > monitor is at 1600x1200. Is there any way to overcome this problem? >(i.e. > > to have full screen on both monitors) > > >Yes, set your 19" monitor to 800x600 when you run MPLAB, or get >your 15" monitor to run at a higher resolution. Look at screen settings, >'advanced' to see if you can lower the adaptor refresh rate >or go to interlace mode to get a higher resoloution yet stay within >your older monitor's capabilities. Interlaced 600 will give you the >1200 lines you need to match you 19", but I doubt that your >1600 pixels would be very clear. > > > > Thank you in advance! > > Thomas > >-- >http://www.piclist.com hint: The list server can filter out subtopics >(like ads or off topics) for you. See http://www.piclist.com/#topics > > _________________________________________________________________________ Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com. -- http://www.piclist.com hint: The list server can filter out subtopics (like ads or off topics) for you. See http://www.piclist.com/#topics