OOPS!  Sorry for the resend.  I didn't get the topic line correct.

Hello everyone,

I found out this weekend that I a PID loop for the motor control on my bot.
I'm using the F877's PWM output to control my drive motors thru an H-bridge
setup.  The motor has a shaft protruding from both sides.  The wheel will go
on one side and I'll put a shaft encoder of some type of the other side.
With the shaft encoder, I'll be able to determine speed, direction, stall,
and whatever else I need.

I have NO clue about a PID loop, so if someone could give me some code to
look at and get an understanding, I'd greatly appreciate it!

Thanks,

Duane Brantley

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads