Edgard,
Here is the section of the ICE2000 manual that describes the =
overcurrent
condition:

B.5.1 Power LED (P)
This LED is located on the front panel of the pod and is lit when the
system is
sufficiently powered.
The LED will turn off if the internal system voltage falls below a 4.65
(=B15%)
volts, indicating a low power condition. If this occurs, power should =
be
removed until the cause of the low voltage is determined.
On pods with an electronic circuit breaker, the LED will blink if there =
is a
system fault. The rate of blinking determines the type of fault.
The system may be reset from a fault by turning off the pod and then
turning it
back on. If a condition persists, please contact Microchip support.

LED Condition
On      System is sufficiently powered.
Off     No or low power condition.
Blinking Fault detected.

Blink Rate Meaning
2 per second    Overcurrent condition (more than 3 A.)
8 per second    Undervoltage condition (equal to or less than 4.65V.)
3 rapid, pause, 3 rapid Undervoltage condition on processor module.

It looks to me like if the fault can not be cleared by cycling the =
power it
will have to go back to Microchip.

Bill

At 02:28 PM 05/08/2001 -0500, you wrote:
>Dear Friends
>
>I have bought emulator MPLAB ICE 2000, I am proving it but a condition =
of
>sobrecurrent appears an error in the LED P indicating. The equipment =
is
new.
>I have disconnected all cables, nevertheless continues appearing the =
error.
>I thank for any aid to them.
>
>Edgard Oporto
>Lima PERU
>
>PD Excuseme the english.
>
>--
>http://www.piclist.com hint: The list server can filter out subtopics
>(like ads or off topics) for you. See http://www.piclist.com/#topics
>
>





---------------------------------------------------------------------
This message (including any attachments) contains confidential, =
proprietary
or privileged information intended for a specific purpose and =
individual(s),
and is protected by law.  If you receive this message in error, please
immediately delete it and all copies of it from your system, destroy =
any
hard copies of it and notify the sender.  Any unauthorized disclosure,
copying or distribution of any part of this message, or the taking of =
any
unauthorized action based on it, is strictly prohibited.

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics