Does the MPLAB Simulator support the PD status bit when
doing an MCLR?

I am simulating (or trying to) a 16C56 coming out of
SLEEP when MCLR is set low (and then high).

I execute a SLEEP and see the PD bit (Status bit 3) go low.
I then do Debug>Run>Reset to simulate a MCLR.
The PD bit is set high.

The datasheet (30453c, 16C5X) indicates that PD is not
changed by MCLR (table 4-1, page 18).

Is this a simulator bug?
Is there another method of simulating MCLR?
Or am I misunderstanding the chip operation?


David W. Gulley
Destiny Designs

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body