At 06:12 PM 3/30/01 +0100, Chris Pringle wrote:
>Hi,
>I'm building a development board for the PIC16C64B. This has an LCD
>permantly attached, and several I/O pins that are free to do whatever I
>want with. I also want to be able to select 2 sources for my Oscillator
>input. Is there going to be any problem with running the output from my
>oscillator and RC circuit through 30cm of Ribbon cable (with a switch in
>the middle)? Will I get too much interference?

Depends on frequency, but this is generally a bad idea.
Much better to put the oscs on the other end, and select them over the cable.


--
Dave's Engineering Page: http://www.dvanhorn.org
Where's dave? http://www.findu.com/cgi-bin/find.cgi?kc6ete-9

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.