I'm trying to communicate to a DS1820 via a DS2480.
But it is still,a bit confusing to me, when to switch to Data-Mode
or Command-Mode,and when to send Reset-Codes and so on. As this is my
first 'contact',with the "1-wire-world", I would really appreciate a
little help, some sample-code showing how to read the temperature
from the DS1820 (via,a DS2480 !) would help a lot. Or even a something
like:
Write E1
read ..
Write ...
Write ...
read ... (should have the value ....)
etc.

regards,
   Reelf

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads