Dear all,

I think I asked this once before, but no harm in asking again...

Does anyone have any code for accessing flash memory? I have all the
routines for I2C, but the flash I am thinking of (Toshiba
TC58FVT160FT-85) uses parallel addressing, which I presume is actually a
lot easier than serial. Before I give it a go, I wondered if anyone out
there has tried it?

TIA,

Chris
--
Dr. Chris Kirtley MD PhD
Associate Professor
HomeCare Technologies for the 21st Century (Whitaker Foundation)
NIDRR Rehabilitation Engineering Research Center on TeleRehabilitation
Dept. of Biomedical Engineering, Pangborn 105B
Catholic University of America
620 Michigan Ave NE
Washington, DC 20064
Tel. 202-319-6247,  fax 202-319-4287
Email: kirtley@cua.edu
http://engineering.cua.edu/biomedical

Clinical Gait Analysis: http://guardian.curtin.edu.au/cga
Send subscribe/unsubscribe to listproc@info.curtin.edu.au

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads