Can anyone point me towards an adaptor to convert the PLCC68 socket on my board
to a PLCC68 ZIF before I bend the pins on another windowed 17C756!

I could replace the socket on my board with a ZIF but the ones I've found so
far are too wide/deep to fit the space available except the burn-in sockets
which seem to have a different pin layout for some reason.

I know I should buy a 17C75x emulator but I can't justify it at this time
unless
there's a low cost one out there?

Thanks.

Nigel

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu