On Sun, 5 Nov 2000 03:55:19 -0600, you wrote:

>    Hello. I have a problem with the startup on the 16F877.
>
>In the startup the PIC start slowly, and it take a few seconds for begin=
 (2
>or 3 seconds). Then, the LED's that I have connected to the PIC they =
blink a
>little, until finally they light up and the PIC works correctly
>
>I using the PIC to decode a IR Sony, to read a ADC pin and to generate =
an
>PWM out (for the mometo)
>
>When I run small programs, or I modify (several modify) the current =
program,
>the problem disappears or he attenuates.
>
>As data I count them that the clock is of 4 MHz, the source is regulated=
 and
>very reliable (5V), etc.
>
>The program begins settings the corresponding TRIS. Then turn on the pin
>PORTA,1. Then reads two pines of the port B to decode IR Sony, it =
filters
>the data and turn on a LED in the PORTA,1 if the codes are correct. The
>program waits a "four digit key" and, if it is correct, when pressing =
the
>key DISPLAY, he gives an exit PWM given by an analogical entrance by the
>PORTA,0
>
>The program in MSPAM is in
>http://members.nbci.com/_XOOM/chicomalo/IRsony.asm
>
Sounds like either the MCLR pin is floating, or you have Low Voltage
Programming (this is the default) enabled and RB3 is floating.=20

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.