From: Bill Kaufman@MITEL on 10/17/2000 01:35 PM Why not install an Amphenol 50 pin connector on your board and use standard telco 25 pair cables to terminate to an R66 block or whatever? You end up making your board thicker to absorb the shock from the punch tools if you mount then directly on your PCB. My 2.5 cents. Bill David Blain on 10/17/2000 11:37:19 AM Please respond to pic microcontroller discussion list To: PICLIST@MITVMA.MIT.EDU cc: (bcc: Bill Kaufman/Ogd/Mitel) Subject: Re: [OT]:Can't find part anywhere! Yes, Alan & Adam are correct. I need to terminate multiple pairs of wires (~16). They will be connected to RJ11 & RJ45 jacks which will be used to allow the customer to rewire connections using short patch cords. Unfortunately, they do not want to use a separate patch panel. I could always use screw terminals, but none of us are thrilled about that idea. Thanks for any/all help, David. ----- Original Message ----- From: "M. Adam Davis" To: Sent: Tuesday, October 17, 2000 11:21 AM Subject: Re: [OT]:Can't find part anywhere! > Yes, that's what he is after. > > -Adam > > "Alan B. Pearce" wrote: > > I understood that he is asking for a wire termination unit, like the telephone companies use with insulation displacement punch downs. Yes/No? > > -- > http://www.piclist.com#nomail Going offline? Don't AutoReply us! > use mailto:listserv@mitvma.mit.edu?body=SET%20PICList%20DIGEST > > > > -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! use mailto:listserv@mitvma.mit.edu?body=SET%20PICList%20DIGEST -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! use mailto:listserv@mitvma.mit.edu?body=SET%20PICList%20DIGEST