Hi guys,

About one month ago lightning struck my house killing my PC and parts of my
development system. I have it all up and running now, but the pre-programmed
chip in the ICD was fried and I replaced it with a backup (V1.22). I
downloaded the very latest version of MPLAB from Microchip and got back to
my project.

The only problem is that every single time I run MPLAB I have to reset the
oscillator, brownout, powerup, LVP etc, etc settings as they are all wrong.
Nothing I have tried seems to help. I never had this problem before.

Is it something new in this version of MPLAB, or perhaps an incompatibility
with older ICD firmware?

Any ideas?

David Thompson

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu