At 11:51 PM 02/10/00 -0400, you wrote:
>Jim Robertson wrote:
>>At 10:43 AM 02/10/00 -0400, you wrote:
>>>Igor wrote:
>>>I've purchased the pic16f84A (A is important!) and I've spent
>>>couple of hours to get programmed the chip (I have dtait
>>>lpt programmer and no problems with lot of pic16f84, sw I use is
>>>wpicprog32 from nigel goodwin v 1.2 and 1.22).
>...........
>>
>>Actually Dan,
>>
>>The config word is different between the 16C84 and the others. The above
>>information does not include any config word information that I can see.
>>Like any good programmer software the EPIC is relying on the correct
>>config values being provided via the HEX file and ultimately via the
>>assembler/compiler. It is in these software tools that differences in the
>>config word should, and are defined.
>>
>
>
>Ooops, you are correct, Jim. 'C84 is different. However, it does
>look like the 'F84 and 'F84A have the same config word, so Igor should
>not have to change parameters between the two. Correct? And his problem
>is probably somewhere else.

Yes and yes. I think Igor has a problem in the electrical side, maybe
the PSU slew rate is too high or it is overshooting causing latch-up.

-Jim

>
>- danM
>
>--
>http://www.piclist.com#nomail Going offline? Don't AutoReply us!
>use mailto:listserv@mitvma.mit.edu?body=SET%20PICList%20DIGEST
>
>
>
Regards,

Jim Robertson
NEWFOUND ELECTRONICS
Email: newfound@pipeline.com.au
http://www.new-elect.com
MPLAB compatible PIC programmers.

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu