The config bits were definetly set to RC. My big problem is I'm net to PICs
really (1 year), and I'm still trying to learn how they're wired up... I
followed the diagrams in the manual for the microchip but it's all a little
confusing and not always consistant. Do you know how they are supposed to be
wired up?
Regards,
Chris Pringle

----- Original Message -----
From: "Scott Dattalo" <scott@DATTALO.COM>
To: <PICLIST@MITVMA.MIT.EDU>
Sent: Saturday, September 23, 2000 10:09 PM
Subject: Re: [PIC] PIC16C64B Development board.


> On Sat, 23 Sep 2000, Chris Pringle wrote:
>
> > Hi All, I'm trying to build a development board for a PIC16C64B
> > microprocessor so I can stop making all the PCBS which are "wrong". Does
> > anyone know how to wire up this microprocessor in RC mode? I've read all
the
> > literature, but no matter what I do, I could not make this chip work on
the
> > PCB. I want to make sure I'm wiring it up the right way before I make a
> > development board, cos I'm a little short on time...
>
> Chances are your board is fine, but your CONFIG bits are set for HS. Are
you
> sure the CONFIG bits are correct?
>
> Scott
>
> --
> http://www.piclist.com hint: To leave the PICList
> mailto:piclist-unsubscribe-request@mitvma.mit.edu
>
>

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu