Not one reply, so I will ask again.

Help please. Any clues will do.
I seem to have a problem with 2 of my I2C chips. After receiving help =
from Andy Stubbins I now have the 877 talking to my 24LC65 Eeprom via =
the  I2C MSSP.=20

The clock and thermometer chips do not respond. The I2C pcb was moved =
from a 16F84 test pcb to the 877 test pcb so I know it works. I wondered =
if the other chips do not support 400Khz mode so I changed to 100Khz. I =
started the '877 at 20Mhz but changed to 4Mhz adjusting the setup as I =
went. I now have 2 pluggable xtals. They both work OK, 877 starts, LCD =
displays a message from eeprom .=20

I am using 22k pull-ups and have added 2 more in parallel to reduce the =
resistance and test the signal rise time. I used converted code, pin =
bashing the I2C pins to test the electronics which worked. Any ideas why =
these other two chips do not respond??

Thanks in advance. Chris Chamberlain.

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu