Michael -

I built the propic2 hardware and used the software.
I too had problems at first - but they were caused by me
making mistakes in building the programmer.

Have you contacted Octavio?

Have you verified your hardware is 100% correct before
saying the software doesn't work?

What device are you trying to program?

Mike Gann





lu01ts@gmx.net wrote:
>
> Hello picsters,
>
> is here anyone on the list, who is using propic2 programmer-software ?
>
> I just finished building the hardware, but now i have encountered some
> problems withe the software. It's only the unregistered version, but I
> think this won't be the problem.
>
> 1) After programming the pic an error I get an error message 'pic not
>    equal at 3h'. Reading out and reprogramming the pic will give no
>    error message, but the contents of 3h is 2900h instead of 3fff (as
>    it was in my original hex-file).
>    I've tried this with SQTP switched on and off ...
>
> 2) Blanking the device before programming will write the device, but
>    address 0h is not written correctly.
>
> 3) Canceling the save-box with either 'esc' or the 'cancel'-button
>    quits the program completely.
>
> All in all I feel a bit disappointed about a software sold for
> money ... have used pip02 - software which worked for free :-(.
>
> So the final question would be if anyone knows if there's another
> software working with the propic2 hardware.
>
> --
> Best regards,
>  Michael                          mailto:lu01ts@gmx.net
>
> --
> http://www.piclist.com hint: To leave the PICList
> mailto:piclist-unsubscribe-request@mitvma.mit.edu

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu