Hello picsters,

is here anyone on the list, who is using propic2 programmer-software ?

I just finished building the hardware, but now i have encountered some
problems withe the software. It's only the unregistered version, but I
think this won't be the problem.

1) After programming the pic an error I get an error message 'pic not
   equal at 3h'. Reading out and reprogramming the pic will give no
   error message, but the contents of 3h is 2900h instead of 3fff (as
   it was in my original hex-file).
   I've tried this with SQTP switched on and off ...

2) Blanking the device before programming will write the device, but
   address 0h is not written correctly.

3) Canceling the save-box with either 'esc' or the 'cancel'-button
   quits the program completely.

All in all I feel a bit disappointed about a software sold for
money ... have used pip02 - software which worked for free :-(.

So the final question would be if anyone knows if there's another
software working with the propic2 hardware.

--
Best regards,
 Michael                          mailto:lu01ts@gmx.net

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu