Hi Don,

I believe both 100R and 10K are correct. If you have a look how RB6 and RB7
of the target are driven (signals are named RC3X, RC4X to ease up
orientation :-), there is 330R from the 'driving' pin and 10K to the
'sense' pin. ICD firmware undoubtly checks that the target does not
override applied signal levels. Since the R33 goes to the so far unused
RCX0 (supposed to drive target RB3), I guess the resistor value doesn't
matter at all. Even if the RCX0 is used in future firmware upgrades, the
sense pin will see correct level thru 100R as well as 10K resistor.

Josef

>BTW, I briefly looked at the schematic on your page. I didnt really
>check it much, but I noticed one thing that might be an error, or
>maybe its a microchip error that you have fixed. Anyway, you have
>R33 shown as 10 Kohms, but in the schematic I got from
>microchip, its shown as 100 Ohms. ??


=======================================================================
Electronical devices for chemical laboratory, custom electronics design
-----------------------------------------------------------------------
Snail Instruments                      Josef Hanzal, M. S.
Vojanova 615                           phone/fax: +420-311-624433
266 01 Beroun                          e-mail: snail@iol.cz
Czech Republic                         URL: http://www.vitrum.cz/snail/
GPS: 49deg58'28" North, 14deg 4'35" East
=======================================================================

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]: PIC only [EE]: engineering [OT]: off topic [AD]: advertisements