On Mon, 29 May 2000 18:13:33 -0400, you wrote:

>I always use 16J probe same as 73 the only time it didn't pass the test it
>was
>
>1. if your probe is in circuit
>2. J5 jumper is on external 5v
>3. J4 clock is on external
>4. if you are using internal PC power supply you should have
>    at list 350 Watt power supply I recommend external power
>    supply
>
>Andre Abelian
>
>
>> > Hi,
>> >
>> > The new 16C73 pod attachment for my Picmaster does not pass the verify
>> > PICmaster test. I have one of the older PICMASTER units and I was
>> wandering
>> > if there had been a software upgrade?  I am using MPLAB.
>> >
>> > I was told that the pass counter would fail some all of the time, but I
>> would
>> > expect the other test to pass.
>> >
>> > The pods have been discontinued I am told and the PICMASTER is not
>longer
>> > manufactured.  Does anyone have a good source for repairing such
>> equipment?
>> >
>> > Paul
>> >
>>
Check that the global break disable isn't active - this will cause
several tests to fail (ensure little box on status bar says 'Bk On'
not off