At 05:25 PM 5/27/00 +0200, you wrote:

Yes, it must nessasarily support the 16C58 if it supports both the 16C54 and
16C57. This is true even if it doesn't say so on the box. Select the 16C57 and
put the 16C58 where you would put the other 18-pinners.

This will work.

-Jim

>Does anyone know of software for David Tait's 16c5x programmer, that would
also support 16c58, i know that supports 54,55,56,57.
>
>
>******************************************************
>SRECNO
>******************************************************
>-address:
>Gregor Stumpfel
>Ljubnica 10 a
>3205 Vitanje
>Slovenia
>-phone:
>(063)775256
>-homepage:
>http://www.uni-mb.si/~uelelt24b/index.html
>-email:
>gregor.stumpfel@uni-mb.si
>******************************************************
>
Regards,

Jim Robertson
NEWFOUND ELECTRONICS
________________________________________
Email: newfound@pipeline.com.au
http://www.new-elect.com
MPLAB compatible PIC programmers.
________________________________________